New % Fiio X1II. The successor of the king of low cost audio

FiiO X1II

New

110,00 EUR

120,00 EUR

In stock

Quick Overview:

Portable music player  FiiO X1 II (2nd generation). The next king of low cost audio.

More details


All new FIIO X1 II (2nd generation). Portable audio player


AUDIO PLAYER DESCRIPTION

Comprehensive improvement of hand feel starting from the touch wheel
By studying and comparing dozens of designs and through hundreds of experiments and test, we have finally developed the unique Fiio touch wheel with higher sensitivity, better anti-interference, enhanced reliability and longer service life.

Wireless Bluetooth 4.0 allowing you to enjoy music easily
The Bluetooth 4.0 system based on F1C81 chip set allows you to easily enjoy the music with reduced latency and high sound quality.

Getting rid of the wire to achieve two functions
Two-way transmission allows it to receive Bluetooth signal while sending Bluetooth signal (RM1 can be used at the same time when Bluetooth headphone or Bluetooth speaker is on.

Not limited by wire
Being not restricted during exercise, you may have good sweat while enjoying wireless music.

On-board music accompanying you on the way
In-the vehicle mode provides a perfect link between music and vehicle audio system, which has greatly improved the acoustic quality of vehicle audio system and let you enjoy music on the way.
When vehicle engine is ignited, X1 II is turned on too. When you shut down the engine X1 stops immediately. There are no tedious manual operations any more.
*To ensure better sound quality, AUX line connection is suggested for on-board mode.

Dedicated professional high quality DAC chip
Utilizing Texas instruments’ high quality CM5242, the all new X1 gets higher signal to noise ratio and supports full differential line output to achieve balanced line output function, as compared with PCM5142 of the last generation.

Further optimized architecture
With dedicated LPF and operational amplifier we have optimized design of power architecture and circuit at the same time to further improve sound quality of the all new X1, making better low-frequency quality and depth.

Strong lossless format support
It supports the five common major lossless music formats: APE/FLAC/WAV/WMA/ALAC. At up to 192kHz/32bit

Improved line output functions
It supports both headphone output and line output, which can be used as audio source to you amplifier to increase your pleasure in the listening to music. Line output can be easily set in system settings.

New deep-sleep standby design
Deep-sleep standby enables instant-on playback. Stand by as long as 15 days allows music to be your companion at any moment.

In-Line remote control function
Improved in-line remote control function can effectively adapt to most headphones available on the market, in addition to a new function of volume adjustment
*Do not support volumen control of apple EarPods

Light and portable
Full aluminum alloy and cineast design provides a better hand feel (97x55,5x12 (mm))

Humanized design
Arc waist design is employed to provide better hand fitness and feel.

All-new UI themed interface
Continue to use 2.0 inch color display with a resolution of 320*240, plus characteristic UE operating system (with three built-in color themes availablee at your choice)

Music enjoyment for 30 thousand minutes
It supports micro SD card up to 256g. When calculated by 30 MB for a piece of lossless music, it can accommodate approximately 8.738 pieces of music. If a piece of song last for four minutes, you may liste for 34.952 minutes, i.e.2.098 hours or 87 days.


Technical specifications

  • Display screen: TFT320x240
  • Analog Audio Output jack (LO) 3,5mm headphone output jack
  • Digital Audio Output jack: N/A
  • USB DAc /N/A
  • Headphone out (PO): 3,5 mm headphone output jack
  • Headphone Impedance range: 16-100 Ohm
  • Volumen control Type: 100 steps digital potentiometer
  • Bass boost_ N/A
  • Treble: N/A
  • Blanca: 5db
  • Gain selection: N/A
  • Equalizer: 7 band equalizer (+/- 6db)
  • Dimensions: 97x55,5x12 (mm)
  • Weight: 102g

Partial performance parameters for line output

  • THD+N: ≤ 0.003% (1 kHz)
  • Frequency Response: 5 Hz~60 kHz (-3dB)
  • Crosstalk: ≥ 101 dB (10 KΩ/1 kHz)
  • SNR: ≥115 dB  (A-weighted)
  • Dynamic range: ≥107 dB

Partial Performance Parameters for Headphone Output

  • Output Power 1: ≥ 90mW (16 Ω/THD+N<1%)
  • Output Impedance: <1Ω(32Ω loaded)
  • Output Power 2: ≥ 70 mW (32 Ω/THD+N<1%)
  • Crosstalk: ≥72 dB (1 kHz)
  • Output Power 3: ≥ 8 mW (300 Ω/THD+N<1%)
  • THD+N: ≤ 0.003% (1 kHz)
  • Frequency Response: 5 Hz~60 kHz (-3dB)
  • MAX output voltage: >4.0 Vp-p
  • SNR: ≥113 dB (A-weighted)
  • MAX output current: >130 mA (For reference)

Power and Battery

  • Power: Recommend DC5V 2A
  • Battery Capacity: 1800 mAh
  • Charge Display: Red light indicates , green light turns on after fully charged
  • Battery Display: Yes
  • Battery Life: >12 h
  • Charging Time: <3 h (DC5V 2A)

Audio Format supported

  • Lossless: APE(Fast): 192 kHz/24 bit, APE(Normal): 96 kHz/24 bit, APE (High): 96 kHz/24 bit, FLAC: 192 kHz/24 bit, WAV: 192 kHz/32 bit, iff:192 kHz/32 bit, Aif:192 kHz/24 bit, WMA Lossless: 48 kHz/24 bit (to be supported by future update), Apple Lossless: 192 kHz/24 bit
  • Lossy compression: MP3, AAC, WMA, OGG, etc.

Packaging and accessories

  • Packaging: Cardboard package box
  • Dimensions of package: 98mmx168mmx42mm
  • Cable: 1m high current micro USB data/chrging cable
  • Clear case: transparent
  • Screen protector: 2 included (1 applied in factory)
  • Warrant card: 1 copy
  • Quick start guide. 1 copy
  • Bodywork sticker: 2 sets
  • Hi res sticker: 3 pcs

 
FiiO X1II

FiiO X1II

Portable music player  FiiO X1 II (2nd generation). The next king of low cost audio.

Write a review !







No reviews at that time.


FiiO X1II <p><strong>Portable music player  FiiO X1 II (2nd generation). </strong>The next king of low cost audio.</p> 110

27 other products in the same category: